The feeding chutes are supported by Ø89 impact rollers, which are made of hot rubber wrap, and are completely wrapped in the band under the band to prevent wearing.
This system prevents the band from wearing from the bottom by supporting the material from the bottom during the first pouring.
The discharge chute is produced as a stone box to reduce wearing and to ensure the smooth flow of the material.
The feet of the belt conveyor will be produced from heavy-duty pipes.
The Bearings will be placed inside the rear drum so that the rear drum shaft will be fixed and will not rotate.
GURSAN belt conveyors are produced with a screw tensioning system up to 39 meters in length, more than 40 meters weighting tensioning system will be used.
GUR-SAN conveyors will be equipped with inspection platforms for following the operation. There are several options which will be served to customer decision; conveyors equipped with the one-sided platform, two-sided platform. These platforms which will be expanded metal or galvanized grids can be surrounded by drive drums or not surround.
Again according to the customer demand, the top of the conveyors can be closed against dust with sheet metal which will be snapped on a cross over to each one.
According to operation belt conveyors can be produced as radial type. With the help of this specification, conveyors can make stock in larger areas.
Also if the customer wants to make stock due to quality differences and make stock in larger areas also can select tripper-type belt conveyors.